How To Solve The Problem Of Frosting In The Low Pressure Pipe Of Automobile Air Conditioner

Jan 07, 2023 Leave a message

Icing of car evaporator / icing of air-conditioning pipe / frost Routine thinking: first check whether the air-conditioning drain hole can drain normally, then check whether the data of the temperature sensor of the evaporator and the installation position are normal (if abnormal, replace and reset), and finally reinstall Inject refrigerant (according to the actual situation, if necessary, replace the dry bottle/dry bag, expansion valve/throttle valve, and clean the air-conditioning pipeline to ensure that there is no moisture inside. Before adding new refrigerant, be sure to Make sure the air conditioning system is clean and leak-free).
In addition to the above ideas, the influencing factors of the air-conditioning control system (such as air-conditioning panels, control units, etc.) cannot be ignored.
Automobile evaporator icing/air-conditioning pipe icing/frost maintenance case BMW 740L air-conditioning pipe intermittent icing Description: Model: a BMW 740L with a mileage of about 150,000 km equipped with M54 electronically controlled engine, automatic transmission and automatic air-conditioning system car.

Fault phenomenon: User feedback: During the driving process of the vehicle, the air output of the air conditioner gradually decreases until there is no wind blowing out. Turn off the engine, wait for a while and start the vehicle again, the fault phenomenon disappears, but it will reappear again after that. Judging from the fault symptoms, the possibility of ice blockage is relatively high. Carry out a road test to confirm the fault symptoms. After about 30 minutes, it is found that the air outlet gradually decreases to no wind.
Maintenance plan: stop and check, and find that the outer wall of the low-pressure pipe of the refrigerant pipeline is frosted, indicating that the fault is indeed caused by ice blockage. Go back to the factory for a comprehensive inspection, use the diagnostic instrument to self-diagnose the automatic air conditioning system, and the result is a fault code about the evaporator temperature sensor. Find the sensor, check the wiring connection, no problem. It was suspected that the performance of the sensor was too poor, so it was replaced. Tried the car, the fault didn't improve.
Use a refrigerant identifier to detect the refrigerant type and purity, and find that the system is mixed with R12 refrigerant, and the car is equipped with an R134a system.

Send Inquiry