(First Article) Does The Bus Air Conditioning Compressor Need Maintenance?

Jan 20, 2023 Leave a message

The main contents of automobile air conditioning compressor maintenance include the following eight aspects:

(1) Check the tension of the compressor belt.
The tension of the car compressor belt is 376N50n (about 38kg5kg). If the belt tension is too high, it is easy to cause early failure of the compressor pulley bearing. It means the compressor is noisy. If not repaired in time, the clutch will be damaged. The tension of the belt is too small, which will cause the belt to slip, which will cause the speed of the compressor to drop, and the cooling effect will not be good. In normal use, the driver can turn the belt over by hand. If the belt can be turned 90 degrees, the tension is basically normal.

(2) Maintenance of the evaporator.
The evaporator, like the condenser, is a heat exchanger, so it is required to keep the vents clean, the drainage channels unblocked, and the fans running normally. When the car is at maximum cooling, pay attention to check whether the engine hot water leaks through the warm water valve, so as not to affect the cooling effect.

(3) Liquid storage tank.
After two years of normal use, the liquid storage tank should be replaced in time, because the desiccant in the liquid storage tank will become invalid after about two years of use. If it is supersaturated to absorb water, the drying bag is easy to burst, and the desiccant powder will block the pipeline. Every time the pipe is disassembled for maintenance or cleaning, it must be replaced with a new liquid storage tank.

(4) Throttle device.
The throttling device used in the front air conditioner of the car is a throttle tube, and the rear air conditioner uses an expansion valve. When cleaning the pipeline, it is best to replace the throttling device at the same time, so as not to block the pipeline again, or even damage the compressor. No matter what kind of expansion valve is used, it is absolutely not allowed to adjust the opening of the expansion valve in order to pursue the cooling effect, otherwise the light one will affect the cooling effect, and the heavy one will cause the compressor liquid hammer.

 

                                                                                                                                                                                                                                                                                                                                                    (From:Pacific Automotive Network)

Send Inquiry