Engine Cranks But Won't Start? How to Test & Replace the 42-0100 Fuel Shut-Off Solenoid

Nov 20, 2025 Leave a message

Products Description 

Engine Cranks But Won't Start? How to Test & Replace the 42-0100 Fuel Shut-Off Solenoid

info-1-1

1. Safety & Preparation

Ensure the vehicle is in park/neutral with the parking brake set.

Disconnect the battery's negative terminal as a precaution before electrical testing or replacement.

2. Testing the Solenoid (Is it Good or Bad?)

Locate the Solenoid: It's typically mounted on the side of the fuel injection pump.

Listen for the "Click": Have an assistant turn the ignition key to "ON" (not start). You should hear a distinct audible "click" from the solenoid as it energizes and opens. No click suggests an electrical or solenoid failure.

Electrical Check: Use a multimeter to test for 12V power at the solenoid's electrical connector when the key is turned on. If there's power but no click, the solenoid is likely faulty. If there's no power, the issue is in the wiring, fuse, or ignition circuit.

3. Replacing the Solenoid

Disconnect: Remove the electrical connector and the fuel lines attached to the solenoid.

Remove: Unscrew the old solenoid from the injection pump. Be prepared for a small amount of fuel spillage.

Install: Screw in the new 42-0100 solenoid by hand, then tighten to the correct specification (avoid over-tightening). Reconnect the fuel lines and electrical connector.

Prime & Test: Reconnect the battery. Prime the fuel system to remove air. Turn the key to "ON" and listen for the click before attempting to start the engine.

 

 

 

Send Inquiry